ALL-TEST Pro, LLC 33IND

ALL-TEST PRO 33IND ELECTRIC MOTOR TESTER WITH SOFTWARE


ALL-TEST PRO 33IND ELECTRIC MOTOR TESTER WITH SOFTWARE
7 089,00 $


Primo number :AL50012
Brand :ALL-TEST Pro, LLC
Brand number :33IND




Disponibility
In stock

Quantity :



1-888-774-6665 Need help? Contact us 1-888-774-6665


ALL-TEST PRO 33IND ELECTRIC MOTOR TESTER WITH SOFTWARE OFFERS IMMEDIATE INFORMATION ABOUT THE COMPLETE CONDITION OF YOUR STATOR, ROTOR AND CONNECTIONS! The AT33 IND instrument is the PERFECT TOOL for troubleshooting, inspection of incoming or stored motors before installation, or repair. It quickly shows the complete condition of the Stator Windings, the Rotor, Contamination, Ground Fault and Connections. - EASY & QUICK TEST TO CHECK YOUR ELECTRIC MOTORS: This instrument presents an exciting breakthrough in off-line (de-energized) testing. Within minutes the operator can get a complete picture of the condition of a motor without having to stress-test the windings or use other more expensive or elaborate instruments, which can be difficult to operate and analyze captured data with. - TWO TESTS IN ONE The instrument can be used in two modes: Static and Dynamic. Both quickly collect data in auto mode and there is no need to operate a lot of difficult to understand buttons. - THE STATIC TEST can be performed at the control panel and takes only a few minutes per motor! It tests “the whole loop”, i.e. cable, connections and stator/rotor from the starter/motor drive. No need to disconnect drives and machinery for the phase to phase test. It reports whether a change has occurred between a prior test (the baseline) and the present test. It measures Resistance, Inductance, Impedance, Capacitance and Phase Angle. The fault indicator is not dependent on Rotor position. The Static test is compared to a base-line test that can be retrieved from “Reference Value Static” records in the instrument, or from the optional software. Meg-ohm-test with 500 and 1000 V reading up to 999 Mohm is standard. - NO NEED TO CARRY ALONG HARD TO READ USER MANUALS The unit can be used stand-alone or with software, which enables you to see all the underlying data from the test. For accuracy see our specifications. - DYNAMIC TEST BY ROTATING SHAFT The AT33 IND Dynamic Test analyzes the results for you by showing Bad, Warning or OK for Resistance, Stator, Rotor and Contamination. It is developed for testing <1000V induction motors with squirrel cage rotor. If the Static test needs to be further evaluated, or if no baseline is available a Dynamic test should be done. The DYNAMIC TEST is done with the rotor shaft disconnected to the machinery. It measures in real time, during the manual rotation of the shaft, several measurements. Any problem is easily recognized by even inexperienced operators. It also collects data used for a “signature” of the Stator and Rotor and these signatures allow for a more in-depth evaluation by an experienced user and supports data of other faults showing in the report. - ACCURACY & EASY TESTING The AT33 IND comes with high-quality test leads and 4 wire Kelvin Clips for very accurate data collection. Please see specifications. The lithium batteries support more than 8 hours of continuous use. No need to carry along a manual when testing, all instructions are shown step-by-step on the instrument’s large screen. The result is then automatically shown on the screen as well. By calling up a prior test of the same motor you can easily see if a change has occurred. ------------------------ Keywords: Motor Maintenance and Verification


Accepted payment methods
Visa MasterCard

General terms and conditions
including shipping and delivery
Shipping and delivery

1-888-774-6665
Speak free with one of our advisors


facebook google + youtube linkedin